Zoppas PD33S Manuale Utente Scaricare il pdf (Pagina 4)

CHANGING THE OPENING DIRECTION OF DOORS AND PANELLING

If you wish to change the opening side of the doors

proceed as follows:

 Remove the handles of the doors, if they are side

fixing by screws.

 Take off the plinth pressed on to.

 Remove the inferior hing taking care for the downer

door not to fall off and not to lose the plastic spacer.

Using a 10mm spanner, unscrew the hinge pin and

reassemble it on the opposite side.

 Lift the downer door off the central hing.

 Remove the central hinge taking care for the upper

door not to fall off.

 Take the upper door off the upper hinge.

 Unscrew the plastic bolts of the opposite side of the

place of the central hinge taken out and introduce

them in the holes occupied before by the hinge.

 Unscrew the axe of the upper hinge and screw it to

the hinge on the opposite side.

Place upper door.

Assemble the lower hinge reinforcement in the oppo-

site side it was situated.

For the remaining parts proceed the other way round.

Once finished make sure that all joints close per-

fectly well all around the door and check that the

internal light turns of when the fridge door closes.

How to panel the door

If your appliance is provided with profiles for panelling

and you wish to do so proceed as follows:

 Remove one of the side profiles.

 Losen the screws of the remaining profiles.

 Start putting on the panel where you took off the

profile pushing it right up to the end.

 Replace the profile on this side.

 Fasten all screws.

NOTE: The panel dimensions must be 2 m/m shorter

than the doors. Maximun thickness of the

panel is 4 m/m.

1 2 3 4 5 6 7 8 9 ... 12 13

Nessun commento

Zoppas PD33S Manuale Utente Pagina 4