
7 8
9 1
0
Cleaning the inlet hose and the valve filter
1 2
3
4
Emergency drain
Because of a malfunction, the appliance cannot drain
the water.
If this occurs, do steps (1) through (10) of 'Cleaning the
drain filter'. If necessary, clean the pump.
When you drain the water with the emergency drain
procedure, you must activate again the drain system:
1. When you drain the water with the emergency drain
procedure, you must activate again the drain
system: Put 2 litres of water in the main wash
compartment of the detergent dispenser.
2. Start the programme to drain the water
Frost precautions
If the appliance is installed in an area where the
temperature can be less than 0° C, remove the
remaining water from the inlet hose and the drain pump.
1. Disconnect the mains plug from the mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a container
and let the water flow out of the hose.
4. Empty the drain pump. Refer to the emergency
drain procedure.
5. When the drain pump is empty, install the inlet
hose again.
Warning! Make sure that the
temperature is more than 0 °C before
you use the appliance again. The
manufacturer is not responsible for
damages caused by low temperatures.
Troubleshooting
Warning! Refer to Safety chapters.
Introduction
The start of the appliance does not occur or it stops
during operation.
First try to find a solution to the problem (refer to the
table). If not, contact the Authorised Service Centre.
With some problems, the acoustic signals operate. The
red indicator of the button Avvio/Pausa flashes and one
of the phase indicators comes on, to show an alarm
code:
• Lavaggio - The appliance does not fill with water
properly.
• Extra risciacquo - The appliance does not drain the
water.
• Fine ciclo - The appliance door is open or not closed
correctly. Check the door!
Warning! Deactivate the appliance
before you do the checks.
13
Commenti su questo manuale